Demon Board Install

 

Your Demon Board Kit should include:
  • 2 strips of pins, each with 14 pins
  • A Dip/Zif combo
  • A 4 Pin cable to connect the board to the ECU VIA datalogger Port
  • USB 2.0 Mini-B to Std-B Bulkhead/Bracket/Kit
  • Ferrite Bead  for 4.5mm USB Cable
  • CN2 Latching Header
  • USDM Chip Kit
  • White Spacer
  • Demon Board

                                                                                  

Chip Your ECU as you normally would using the USDM supplied Chip Kit.
USDM-chipped.gif
  *If your ECU was previously chipped for Hondata S300, take the Dual Wipe Socket included, and press that into the bottom side of the Demon Board.  Then carefully press the Demon Board onto the Male pins in the ECU.
 
Take the 2 Rows of Male/Male Pins and Gently press them into the underside of the Demon Board.
     
Now take the white space and screw it in so that the long part is on the top-side of the Demon Board and the screw is on the otherside.
      

Gently and carefully line the pins up on with the Dip Socket in the ECU.