Xenocron Product Instructions

This category is for instructions and install guides for all Xenocron Manufacturer products or "kits"

Xenocron ECU Installation Guide and Information
What you need to know about your Xenocron ECU     We sell two kinds of chipped Honda/Acura ECUs and here is what you need to know about the ECU yo...
Thu, 16 Nov, 2017 at 10:04 AM
DIY Rear Wheel Speed Sensor Kit
Brown Wire = VCC (Voltage to Sensor) 5 volt – 12 volt from the ECU Black Wire is the OUTPUT.  This is what PULSES and what the ECU Reads.  Send this...
Thu, 30 Nov, 2017 at 5:10 PM
11F0 Board VTEC Conversion Kit - Installation Instructions
11F0 Board - OBD1 Honda ECU VTEC Conversion Kit Installation   First desolder all the spots on the ECU marked, C60, J10, Q101, IC14, & D11.  They...
Mon, 22 Jan, 2018 at 10:58 AM
1720 Board VTEC Conversion Kit - Installation Instructions
1720 Board – OBD1 Honda ECU VTEC conversion kits Installation First desolder all the spots on the ECU marked, IC14, Q26, C60, R67, RM11, D11, J10.  T...
Wed, 29 Nov, 2017 at 4:13 PM
1980 Board VTEC Conversion Kit - Installation Instructions
Dear Customer, Thank you for purchasing my 1980 (P75) VTEC conversion kit. First desolder all the spots on the ECU marked, Q26, Q37, Q17, IC14, Q...
Thu, 11 Jan, 2018 at 9:09 AM
PWM ECU Boost Components (Boost by Gear) Installation for OBD1 ECUs, Hondata, Neptune or eCtune
Xenocron's PWM Boost Contol Parts Kit – Installation Instructions For use with OBD1 Honda ECUs and Hondata S300, Neptune RTP or other OBD1 T...
Tue, 16 Jan, 2018 at 9:14 AM
Xenocron 4 Port Boost Solenoid Setup and Plumbing
4 Port Boost Solenoid Installation & Plumbing EX – Vent IN – From Turbo Compressor or Boost Pressure Source A – To Top Section (Diaphragm) ...
Thu, 30 Nov, 2017 at 5:13 PM
Xenocron GM 3 Bar Map Sensor
  A- MAP sensor ground (typically green with white stripe on most Honda/Acura vehicles)   B- MAP sensor signal output (typically white with yellow st...
Thu, 30 Nov, 2017 at 4:45 PM
Xenocron Fuel Pump Relay Kit Instructions (V2)
Xenocron Fuel Pump Relay Kit Instructions ***These are general instructions.  Take time to plan out this installation before you cut or install ANYTHING,...
Thu, 30 Nov, 2017 at 4:54 PM
Xenocron 'Tuner Harness' OBD1 Pass Through Instructions
This is our popular tuner harness which is designed for the average street or dyno tuner to EASILY plug into a customers car and easily power, ground and in...
Wed, 29 Nov, 2017 at 4:49 PM