Xenocron Product Instructions
This category is for instructions and install guides for all Xenocron Manufacturer products or "kits"
1. Install each bosch 044 into the surge tank make sure not to bottom them out in the surge tank. (Leave about 1/16" to 1/8" from lip on bosch ...
Fri, 1 Dec, 2017 at 8:02 AM
OBD0 - OBD1 Conversion harness: REV C Please be careful with this harness. There are 10 wires that need to be connected for proper usage. If there are...
Thu, 11 Jan, 2018 at 9:27 AM
All swap boxes are tested by the manufacturer before packaging and shipping. Please make sure you are confident in your installation abilities or bring...
Thu, 11 Jan, 2018 at 9:25 AM
Installation Instruction for Mobilizer-A0 and Mobilizer-FX01 1. Open the ECU and locate ...
Thu, 11 Jan, 2018 at 1:29 PM
Xenocron Turbo Filter
***BEFORE YOU ORDER YOUR TURBO FILTER, YOU MUST MEASURE THE OUTSIDE DIAMETER OF YOUR TURBO’S COMPRESSOR INLET AND ORDER THE SAME S...
Fri, 1 Dec, 2017 at 4:10 PM
D.I.Y. 3.0 or 4.0 Bar Map Sensor Instructions
Top of Board, sensor gets soldered to the TOP in the same direction as both pictures show.
This ...
Tue, 16 Jan, 2018 at 9:10 AM
2.5 Bar Motorola MAP Sensor Installation Instructions You will receive either the small or the large MAP sensor depending on stock
Dire...
Thu, 11 Jan, 2018 at 9:13 AM
The pinouts are labeled on the unit and it comes with the pigtail shown, if purchased as a standalone piece. Black - GND is Ground Red - PWR is P...
Wed, 26 Sep, 2018 at 12:04 PM